Custom Twisted-In-Wire Brushes
A twisted in wire brush is known by many names, such as spiral, tube, flue, bottle, pipe, boiler or power brushes. They all represent the same brush construction. In essence, a piece of wire is doubled over and bristle material is inserted between the fold of the wire stem. Often, the bristle material is made of stainless steel or aluminum. The wire stem is then twisted into a brush. Ends of the brush can vary, depending on your needs. For example, a twisted-in-wire brush can have a cut tip, rounded tip or bristled tip. It can have a long end or handle, a short end, one with a ring, loop or cut.
Typically the bristle material is located at one end of the brush, and the handle extends from it. However, the bristle can be centered in the wire, with two long ends, one on each side.
The bristle material we put in twisted in wire brushes ranges from metal, such as stainless steel or brass, to synthetic, such as nylon, polypropylene, or PTFE, to natural materials, such as horse hair or hog bristle. Various other bristle materials are available. Give us a call at 1-800-950-7950 or 1-323-724-7777 for a free quote on the materials you need. If custom isn’t want you need, we have various standard brushes that may work for your application, similar brushes would include:
- Stainless Steel Wire Brushes
- Micro Spiral Brushes
- Spiral Brushes
- Paddle Brushes
There are standard lengths for the brush part and wire but Gordon Brush® can make whatever you need. See the table listing below for some of the sizes available.
Not sure what exact measurements you need for your custom block brush? Or would you much rather order a brush through a live person over the phone?
No problem, give us a call! 1-800-950-7950 or 1-323-724-7777
For any other specific brushes you may need, further scan this Web site or call us at 1-800-950-7950 or 1-323-724-7777. If you know you need a custom brush, complete the Custom Twisted-In-Wire Brush Design Form. Gordon Brush® will get back to you within 24 hours with a quotation.
Twisted-in Wire Brush Applications
You may call, fax or e-mail us with your requirements, or you may download the design sheets listed above and fax or mail us the completed sheets to request a quote. We will get back to you within 24 hours with a quotation.
General applications for twisted brushes are: Applying, Pushing, Removing, Cleaning, Spreading, or deburring.
Specific uses for Twisted In Wire brushes can include, but are not limited to:
- Hole – Small Diameter, Closed/Open – Cleaning, Sanding, Deburring, or Lubricating
- Large or Small Tube Cleaning
- Air and Water Purification System Cleaning
- Beaker Cleaning
- Medical Equipment Cleaning
- Medical Procedures
- Dental Procedures
- Electrical Dispersion
- Lightening Prevention
- Lightening Rods
Twisted-in Wire Brush Sizes and Styles
Sizes and Style of twisted wire brushes almost completely depend on your application. The only issues we have are imposed by equipment constraints. Our equipment is state of the art machinery that manufacturers the widest variety of sizes possible. Talk to us about your application and we will work with you to make the product you need.
Contact Gordon Brush today to receive a custom quote or to learn more about how our wire brushes can fit your applications!